WPC Profiles

Wood plastic composite wall panel installation guide

Wood plastic composite wall panel installation guide

Notice Before Installation

  • Before installing it is advised to unpack the wall cladding boards for 48 hours to allow them to adapt to ambient temperature conditions. Always stack the boards on a flat surface. It is not recommended to install wall panels in very cold temperatures.
  • You can use wooden or metal Joist to support your wall panels following the same fitting process as you would for composite Joist.
  • This instruction is for use of cladding for decorative purpose and fixed on existent solid wall. More actions should be taken to avoid leakage if it is used for wall alone.

Wood plastic composite wall panel Installation Profiles

Wall Panel

Wood plastic composite wall panelWood plastic composite wall panelWood plastic composite wall panelWood plastic composite wall panelWood plastic composite wall panelWood plastic composite wall panel

Joist/Keel

Wood plastic composite wall panelWood plastic composite wall panelWood plastic composite wall panelWood plastic composite wall panelWood plastic composite wall panel

Skirting/Edge

Wood plastic composite wall panel

Screw

Wood plastic composite wall panel

Tools

Wood plastic composite wall panel

Step 1: Install the Joist/Keel

Wood plastic composite wall panel

① Install the joist by Expansion Screws. Keep all joist in same leveling.

② At a 90 degree angle,

 At least 50mm into the surface below.

Wood plastic composite wall panel

③ Joist span at 400mm maximum.

④ Fix the joists maximum 500mm on solid wall.

Wood plastic composite wall panel

⑤ Leave 15mm gap minimum at joist joints.

Step 2: Install the Starter Clips/Strip

Wood plastic composite wall panel

Using a panel, cutting the wall panel clips as starter clips. or cutting for strip.

Wood plastic composite wall panel

②Fit the starter clips/ Strip leveled to the joist at least 25mm from the bottom ends.

④ Insert the first board into the starter clips/ strip.

Step 3: Install the Panels

Wood plastic composite wall panel

① 25mm based on the joist thickness. If joist thickness 30mm , please keep it 30mm.

② Fastening the wall panel with Screw.Wood plastic composite wall panel

③ Repeat the fastening process ensuring that the second board is fitted securely in place on each joist.

Wood plastic composite wall panel

④ Fit other side wall panel. 25mm based on the joist thickness. If joist thickness 30mm , please keep it 30mm.

⑤Repeat this process with each board until you reach the required height.

Step 4: Install the Skirting/Edge

Depending on your installation, you may want to finish off the edges using one of the Skirting/Edge.

Wood plastic composite wall panelWood plastic composite wall panelWood plastic composite wall panel

③ Fit the Skirting/Edge by Screw.

④ Fit the Skirting/Edge maximum 800mm on wall panel

Your Installation is now complete.

If still have any questions, kindly contact SUNFLARE.

Web: www.sun-flare.com                Mail: info@sun-flare.com          Tel: +86 20 82512265

Alibaba: sun-flare.en.alibaba.com

 

Leave a Reply

Your email address will not be published. Required fields are marked *